Contax SW 2524 - REV A Guide d'installation télécharger pdf (Page 45)

Inverter/Charger Installation

975-0639-01-01 Rev A 1–27

This guide for use by qualified personnel only

Figure 1-13 Conext SW DC Connections

Battery or Battery

Enclosure

(2)(a)

(1)

Route the DC cables from the battery bank to the DC Switchgear.

(2) Install a DC fuse (a) on the positive cable near the battery terminal.

(3) Open the DC circuit breaker on the DC Switchgear.

(4) Connect one connector on the POSITIVE (+) cable to the POSITIVE terminal on the DC Switchgear. The

connector goes on first, then the flat washer (steel), then the 3/8” (9.5mm) bolt (brass).

(5) Connect the other connector to the POSITIVE (+) terminal on the battery.

(6) Connect one connector on the NEGATIVE (–) cable to the BATTERY NEGATIVE terminal on the DC Switchgear.

(7) Connect the other end of the cable to the NEGATIVE (–) terminal on the battery.

(4)

(5)

(6)

(7)

Terminal Connection

ConextSW-NA-InstallationGuide.book Page 27 Thursday, December 20, 2012 2:05 PM

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 75 76

Pas de commentaire

Contax SW 2524 - REV A Guide d'installation Page 45