Contax SW 2524 - REV A Guide d'installation télécharger pdf (Page 46)

Installation

1–28 975-0639-01-01 Rev A

This guide for use by qualified personnel only

Step 5: Connecting the BTS and Xanbus-enabled Components

Battery

Temperature

Sensor (BTS)

Installing a BTS extends the life of a battery by preventing overcharging in warm

temperatures and undercharging in cold temperatures. With a BTS monitoring

the battery temperature, the voltage delivered to the battery is adjusted

according to the battery’s actual temperature.

The BTS has a self-adhesive backing and attaches to the side of the battery. The

BTS also comes with a metal tab. A 25-ft (7.6-m) cable is supplied with the BTS.

Xanbus-enabled

Components

These include the SCP, the AGS, Conext ComBox, and a solar charge controller.

The order in which the components are connected to the inverter/charger does

not matter. The most important aspect of the installation of these components is

the attachment of network terminators at each end of the network.

WARNING

ELECTRICAL SHOCK HAZARD

Connect and disconnect DC wiring only after opening and locking out the

disconnect switches or breakers at all AC and DC sources.

Failure to follow these instructions can result in death or serious injury.

ConextSW-NA-InstallationGuide.book Page 28 Thursday, December 20, 2012 2:05 PM

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

Pas de commentaire

Contax SW 2524 - REV A Guide d'installation Page 46